Nexus 0.19.4
Released 26 July 2026. The current release is 1.24.0. Download it · Every version
Worked stations stop showing as needed
Working a station in a US state you had already worked left it lit in the Needed roster with its "why you need this" pills, so a worked station kept looking new. One question — what state is this call in — was being answered by two different sources on the two sides of the same comparison: the heard side resolved it from the FCC callsign index, while the worked side could only read a state written into the log, and auto-logged contacts never wrote one. So a worked state could never be learned. Contacts now carry the state, resolved from the same source both sides use, and existing contacts are filled in once on first launch.
Your Worked All States worked counts will jump the first time you run this. That is the correction, not a bug — they were understated for every auto-logged contact. Confirmed counts are unchanged. The state is written into your log and into uploads to QRZ, ClubLog, eQSL and LoTW, exactly as the country already was.
A contact logged with no grid now reuses a grid you logged for that station before, so a grid you have already worked stops reporting as new. A station whose grid has never been seen still logs blank, because a grid that is not known cannot be credited.
Single-cable interfaces keep CAT
A Digirig Mobile carries CAT and the keying line on one port. Nexus only recognised the opposite arrangement — a separate keying port, as on an SO2R controller — and everything else fell back to keying with no CAT at all, while reporting success. The band never followed and nothing said why. That configuration now keeps full CAT and keying together on the one cable.
Detect recognises Digirig and RIGblaster interfaces, pairs their sound device, and fills in the keying method. It will not guess which radio is on the other end of a cable, so you still pick your Rig Model. Auto-test now also tries the radios these interfaces are usually paired with — FT-891, FT-857, FT-817/818, IC-7100, IC-705, Xiegu G90 and X6100, TS-480.
Keying with no rig model set now says outright that there is no CAT and the radio will not follow the band, instead of reporting a bare success.
Connect shows everything by default
Connect had a Basic / Expert detail level, and new installs started on Basic — one plain sentence per pane. That toggle is gone and every pane now shows its full data. In practice you also get the map layer panels without switching anything, the modelled band-by-hour chart, more satellite passes (14 instead of 5) and more contests (20 instead of 8), and the chase feed no longer stops at three rows. Panes still fall back to a one-line summary while they are waiting on data or a feed is offline — that part was never the detail setting.
Map fixes
Opening sectors on the 3-D globe tore into green spikes that stabbed through the Earth. Nothing in that layer draws curved lines, so the wedge's two long straight edges cut through the sphere and came back out the other side — on a 3000 km opening they passed about 78 km under the surface. The wedge is now drawn in short steps that follow the curve. The 2-D map was never affected, because a straight line on a flat map is straight.
The POTA/SOTA map opened as a flat world map while Chase DX, Ragchew and 6m/VHF all opened as globes. It is a globe now, like the rest.
Digital modes can run plain SSB, per radio
Nexus puts the radio in its DATA submode (DATA-U / USB-D) for FT8, FT4, RTTY and SSTV, because on most rigs that is the only mode where the USB sound device actually reaches the transmitter. That is still the default and nothing changes unless you go looking for this.
If your transmit audio goes in through the microphone instead — an interface wired to the mic jack, as several RIGblaster models are — there is now a per-radio setting, Settings ▸ Radio ▸ Data modes use plain SSB. Nexus then commands plain USB or LSB for those modes and stays there, through band changes and when you call a station.
It is per radio because it depends on how that particular rig is cabled. On a normally-wired radio turning it on means the transmitter gets no audio at all — a red TX light and nothing on the air — so leave it off unless you know your interface needs it. True FSK RTTY is unaffected.
Fixes
- Logging a contact in Voice and CW shows your previous contacts with that station again — the date, band and reports — not just a count of them.
-
The keying port of a radio you were not currently operating could be edited and silently not saved.
It saves.
-
Native Flex audio that fails to start, or starts and never delivers any audio, now says so and falls back to the sound card.
Previously it left you hearing nothing, with silence that looked exactly like a dead band.
- Raspberry Pi packages build again; 0.18.0 shipped without them.
Every version
- 1.24.0 11 Nov 2026
- 1.23.0 5 Nov 2026
- 1.22.0 1 Nov 2026
- 1.21.0 26 Oct 2026
- 1.20.0 22 Oct 2026
- 1.19.0 16 Oct 2026
- 1.18.0 12 Oct 2026
- 1.17.0 7 Oct 2026
- 1.16.0 3 Oct 2026
- 1.15.0 26 Sept 2026
- 1.14.0 20 Sept 2026
- 1.13.0 16 Sept 2026
- 1.12.0 14 Sept 2026
- 1.11.1 8 Sept 2026
- 1.10.3 4 Sept 2026
- 1.10.2 3 Sept 2026
- 1.10.1 1 Sept 2026
- 1.10.0 31 Aug 2026
- 1.9.2 29 Aug 2026
- 1.9.1 26 Aug 2026
- 1.9.0 25 Aug 2026
- 1.8.1 23 Aug 2026
- 1.8.0 23 Aug 2026
- 1.7.6 21 Aug 2026
- 1.7.5 20 Aug 2026
- 1.7.0 18 Aug 2026
- 1.6.1 17 Aug 2026
- 1.6.0 16 Aug 2026
- 1.5.0 16 Aug 2026
- 1.4.0 15 Aug 2026
- 1.3.0 13 Aug 2026
- 1.2.0 10 Aug 2026
- 1.1.0 10 Aug 2026
- 1.0.5 8 Aug 2026
- 1.0.2 6 Aug 2026
- 1.0.1 5 Aug 2026
- 1.0.0 4 Aug 2026
- 0.28.2 3 Aug 2026
- 0.28.0 3 Aug 2026
- 0.27.0 2 Aug 2026
- 0.25.0 1 Aug 2026
- 0.24.0 31 Jul 2026
- 0.21.5 29 Jul 2026
- 0.21.0 29 Jul 2026
- 0.20.0 28 Jul 2026
- 0.19.7 27 Jul 2026
- 0.19.6 26 Jul 2026
- 0.19.4 26 Jul 2026
- 0.18.0 25 Jul 2026
- 0.17.22 25 Jul 2026
- 0.17.21 25 Jul 2026
- 0.17.20 25 Jul 2026
- 0.17.19 25 Jul 2026
- 0.17.18 25 Jul 2026
- 0.17.17 25 Jul 2026
- 0.17.16 25 Jul 2026
- 0.17.15 25 Jul 2026
- 0.17.14 25 Jul 2026
- 0.17.13 25 Jul 2026
- 0.17.12 25 Jul 2026
- 0.17.11 25 Jul 2026
- 0.17.6 25 Jul 2026
- 0.17.5 25 Jul 2026
- 0.17.4 25 Jul 2026
- 0.17.3 25 Jul 2026
- 0.17.2 24 Jul 2026
- 0.17.1 24 Jul 2026
- 0.16.4 24 Jul 2026
- 0.16.3 24 Jul 2026
- 0.16.2 24 Jul 2026
- 0.16.1 24 Jul 2026
- 0.16.0 24 Jul 2026
- 0.15.24 24 Jul 2026
- 0.15.23 24 Jul 2026
- 0.15.22 24 Jul 2026
- 0.15.21 24 Jul 2026
- 0.15.20 24 Jul 2026
- 0.15.18 24 Jul 2026
- 0.15.17 24 Jul 2026
- 0.15.16 23 Jul 2026
- 0.15.15 23 Jul 2026
- 0.15.14 23 Jul 2026
- 0.15.1 22 Jul 2026
- 0.15.0 21 Jul 2026
- 0.14.0 21 Jul 2026
- 0.13.0 19 Jul 2026
- 0.12.0 18 Jul 2026
- 0.11.1 18 Jul 2026
- 0.11.0 18 Jul 2026
- 0.10.0 17 Jul 2026
- 0.9.7 17 Jul 2026
- 0.9.6 16 Jul 2026
- 0.9.5 16 Jul 2026
- 0.9.4 16 Jul 2026
- 0.9.3 16 Jul 2026
- 0.9.2 15 Jul 2026
- 0.9.1 15 Jul 2026
- 0.9.0 15 Jul 2026
- 0.8.9 15 Jul 2026
- 0.8.8 14 Jul 2026
- 0.8.7 14 Jul 2026
- 0.8.6 14 Jul 2026
- 0.8.5 14 Jul 2026
- 0.8.4 13 Jul 2026
- 0.8.3 13 Jul 2026
- 0.8.2 13 Jul 2026
- 0.8.1 12 Jul 2026
- 0.8.0 12 Jul 2026
- 0.7.1 12 Jul 2026
- 0.7.0 12 Jul 2026
- 0.6.0 11 Jul 2026
- 0.5.2 11 Jul 2026
- 0.5.1 10 Jul 2026
- 0.5.0 10 Jul 2026
- 0.4.1
- 0.4.0
- 0.3.0
- 0.2.0 3 Jun 2026
- 0.1.0