hamradiotools

Nexus 1.6.0

Released 16 August 2026. The current release is 1.24.0. Download it · Every version

Fixed

  • FT2 answers in the next slot, not three later.

    The first on-air QSOs exposed it: FT2 keyed each over before the previous slot's decode had folded in, so every reply slipped a full cycle and every message went out twice — both stations reading each other as "didn't copy". FT2 now decodes the completed signal 1.15 s before the boundary and keys with fresh state, exactly like FT4. Its transmission also now starts at the slot boundary, matching the Decodium convention on the air, and the band roster no longer ages stations out four times too fast on short slots.

  • The Phone and CW scope window follows your radio's filter.

    A 500 Hz CW filter inside the old fixed 800 Hz window left dead margins that could never light — the window now spans the filter (plus a little skirt), and Phone's default span is a new Auto preset that tracks the rig's bandwidth.

  • A satellite over can no longer be yanked onto the downlink by a stale keyed-state poll.

    Proven on the wire from the operator's CI-V capture: the mic went down, the once-a-second PTT poll hadn't noticed yet, and the dial-keep pushed the downlink onto what was now the transmit VFO. The rig's own reported frequency is now the evidence — if it reads the pass's uplink, the rig is treated as keyed no matter what the last poll said — and the PTT poll runs five times a second while a pass is up. Works for linear birds too, and a bird's other documented uplink pairing (145.200 vs 144.490 on the ISS) counts as the pass, not as you turning the knob. The pass also pins its transponder row at AOS, ending the first-correction flip between rows the same capture caught.

  • The Phone scope gives the voice three quarters of the panel.

    The centered axis was symmetric, so the (empty, filtered-away) far side of the dial cost half the display and speech looked compressed into one section. The dial line now sits at the quarter mark — left of center on USB, right on LSB — and the occupied sideband gets the rest.

  • The setup wizard's example callsign is nobody's callsign.

    The callsign and grid boxes showed KD9TAW and EN52 as hint text on a fresh install — readable as prefilled values, and they are a real station's. The examples are now N0CALL and FN31 everywhere hint text names a callsign or grid.

  • The Phone and CW scope centers your frequency, the way your rig's scope does.

    Reported from the bench: a station on your own frequency painted at the left edge of the passband. The audio-fed scope's axis started at the dial and ran upward, so the dial sat on the far left pixel with nothing marking it. The Phone scope now puts the dial at the center with a labelled line — voice extends to the right on USB, to the left on LSB, exactly as a rig draws it — and the CW scope centers on your sidetone pitch, so a zero-beat station and the pitch hairline sit mid-window. The quiet half of the Phone display is honest: on the soundcard feed the radio filtered that side away before Nexus ever heard it; rigs with a native panadapter feed (Flex, CI-V scope) show real signal on both sides as before.

  • Satellite passes stop losing their split half a second into an over.

    Found on the air (IC-9700, ISS V/V): a fast dial-read during a keyed over saw the transmit VFO's frequency, read it as you turning the knob, and tore the split down — the rig dropped to simplex on the downlink and keyed there. Three holes closed: the fast read and the dial-keep write now wait while the rig is keyed, and an FM bird's own two frequencies are recognised as the pass (within Doppler) instead of being structurally unrecognisable, which is what made every FM satellite take the teardown path. Doppler keeps correcting the uplink through the over. Needs on-air verification.

  • The uplink mode is now stated, not assumed.

    An FM bird's transmit VFO kept whatever mode the previous pass left on it — this morning that was an inverting bird's LSB on 145.990. Nexus now commands the uplink mode whenever it owns the transmit leg (once per pass, not per tick), and the write reaches the Icom's unselected VFO directly so it lands on the register the rig actually transmits from. Same fix covers non-inverting linear birds.

  • A same-band (V/V) pass takes the 9700 out of satellite mode first, and puts it back.

    The rig's satellite mode is crossband-only, so a V/V pass fought it and lost — Nexus now probes the front-panel state, steps it aside for the pass, restores it after, and says so in the CAT detail. Only a state Nexus changed is ever restored.

  • FM uplinks carry their CTCSS tone.

    The ISS repeater needs 67.0 Hz and Nexus was actively zeroing it on satellite passes — the repeater could never open. Known FM birds (ISS, SO-50, AO-91, PO-101) now key their published tone; the tone ends with the pass.

Added

  • Text that carries your callsign IS your SSTV ident.

    Put your call in any text overlay and the corner ID plate retires — your layout identifies the picture, not the app's stamp. Delete that text and the plate returns on the same draw. The manual "already in the picture" checkbox still works as before.

  • Every waterfall can now be hidden.

    The scope strip in Phone, CW, RTTY, and SSTV joins the ⊞ Panels menu (Operate's already lived there) — on by default, and a hide sticks until you bring it back. The panes below take the freed height.

  • FT2.

    The fast slotted mode from the Decodium community (IU8LMC's WSJT-X fork) joins the FT dropdown: FT4 with a halved symbol time — 3.75 s periods, ~167 Hz wide, decoding to −10.8 dB — for when the band turnover is worth more than the last few dB. Nexus follows Decodium's own band plan (a few kHz above each FT8 hole, 160 m through 23 cm), runs the same auto-sequencer as FT8/FT4, shows a-priori decodes with the same a marker, and logs as MFSK/FT2 so LoTW and the online logbooks accept the record. Built from Decodium's own GPL modem sources (see NOTICE) and proven against its published sensitivity in the test bench — not yet validated on the air against a live Decodium station.

  • Text on your SSTV pictures.

    The composer can now lay text over the picture before transmitting, the way MMSSTV does. One-click CQ, 73 and Reply cards — Reply fills in the other station's callsign from the newest FSK ID heard — plus free text. Two styles: Crisp, the same pixel font as the burned-in ident, proven readable through the decoder; and Banner, big display text with a thick outline. Eight colours, four sizes, and every item carries a solid plate or an outline — that contrast edge is what keeps coloured text readable on the far end. Drag text where you want it (or use the arrow keys); your station ID always draws last, so nothing you add can cover it.

  • Edit & resend from the SSTV gallery.

    The pencil on a received picture loads it into the composer — answer a station's picture with their picture and your text on it.

  • Hunt a grid square by name.

    The watch list (Settings ▸ Spots & Alerts) now takes grid squares alongside callsigns and DXCC entities: enter FN31 or EM7* and get the loud ⭐ alert the moment a station decodes from there, with the Work button ready. A square you ask for by name alerts on every band — the HF grid-quiet default doesn't apply to it.

Every version